Skyline Pedestal Assembly Instructions:

Hardware included:
1 – 4mm Allen wrench
4 – 1½ x 20 JCN cap bolt
4 – 5/16 flat washers
4 – levelers

Unpack top and base components. Place table face down on a clean flat surface. Place the base so that top plate is lined up on table between cleats.

Align the top plate so that the holes in table are visible through the holes in the top plate. Place a washer over a bolt start in the hole that is circled on the top plate of the base. Start remaining three screws with washers. Tighten all screws with Allen wrench.

Insert levelers into the bottom of the feet.

Carefully turn table upright. Place table in position an adjust levelers as needed.